Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Millermatic 251 control board

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Millermatic 251 control board

    Hello, I recently bought a millermatic 251, my issue is with my control board model number ( 220069 ) I noticed that the "R1" resistor (top-middle) had been knocked off, i cant find the resistor in the the machine was wondering if anyone could hook me up and give me the color code banding on their board or send me a photo of there board, so i can figure out the right resistor to put on, i looked all over the internet for a day and cant find even a single photo or diagram please help. Thanks much

  • #2
    Try calling Miller or a repair center, email a photo of your board to them, they may be able to help you, it's worth a try.

    Comment


    • #3
      Serial# from the machine please. All the diagrams go off these codes....

      Comment

      Working...
      X
      Special Offers: See the latest Miller deals and promotions.