Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Cut & Etch

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Cut & Etch

    What are the calculations for determining the leg length and the throat depth when doing a cut & etch.
    I am working to GMW14058 spec which says the leg length should be greater or equal to 0.90t mm min and the throat depth should be greater or equal to 0.70t mm min. My thinest material is 1.0 mm so I would thing that the leg length would be 0.90 mm min and the throat would be 0.70 mm min. Am I correct.
    I have read other places in the forum where the leg length is 1 1/2 times the least material thickness or that
    you take the least material thickness times the square root of 2.0.
    Does anyone know the answer.
Working...
X
Special Offers: See the latest Miller deals and promotions.