Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Update on the generator power

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Update on the generator power

    In an older post I was asking about using gen power/ THD with the 211. Thought I would share what Miller said about it.

    " The Millermatic 211 is pretty forgiving when it comes to input power. As long as you have a generator that is providing roughly 60Hz power and at least 7,000 watts continuous 230 volt power the unit will be fine."

  • #2
    Well, after some time has passed, still have no power. I took the Ridgid gen. back and now have found another half price new in th box.

    6800 running watts is pretty close to 7000 watts, think I should use it???

    The auto idle stopped working on the last one. This one I can't take back.


    At least I would have something until I could do better, but that cash could go towards an engine drive later down the road.

    Comment

    Working...
    X
    Special Offers: See the latest Miller deals and promotions.