Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.


Announcement Module
No announcement yet.

Reduce Post flow gas Maxstar 150sth??

Page Title Module
Move Remove Collapse
Conversation Detail Module
  • Filter
  • Time
  • Show
Clear All
new posts

  • Reduce Post flow gas Maxstar 150sth??

    Is there anyway to reduce post flow on maxstar 150STH? i am wasting a lot of gas on random projects.

  • #2
    I believe it is pre set. How much do you think you are wasting? Post flow helps protect the weld as well as tungsten. I figure if it's gonna flow, its gonna flow on the weld where it will help.


    • #3
      Reduce Post flow gas Maxstar 150sth??

      I think the gas post flow is pre-set depending on the amps your running, the hotter you weld the longer the post flow. I have the same problem. Also does anyone have issues with weak HF?


      • #4
        Turning down your CFH to a bare minimum will help.

        Sometimes when I'm tigging heavy pipe I actually wish it would stay on a hair longer so Miller had to meet in the middle so ya it stays on a little longer than need be when welding on certain things.

        Keep in mind I'm not complaing, Its a great machine.


        Special Offers: See the latest Miller deals and promotions.