Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Hot Start settings: S-74 with AlumnaPro Plus

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Hot Start settings: S-74 with AlumnaPro Plus

    I have a S-74 feeder with an AlumaPro Plus gun. Running 3/64 5356 wire. Welding 5250 plate 1/4" thick. XMT 304 power. No Pulse.
    I would like to improve the hot start settings so that I get less cold lap at weld starts and tacks.
    Could anybody share the settings that they use? and why?
    Thanks
    Kelly
Working...
X
Special Offers: See the latest Miller deals and promotions.