Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.


  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Syncwave error message

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Syncwave error message

    We have a syncwave 200 and two weeks ago had a "POL ERR" message come up. We switched the polarity back and forth and could not get the message to go off. After about 1/2 hour of scratching our heads the message disapeared and we used the welder for two hours with no issues. This weekend we had the same issue however the message never went away and we could not use the welder. Any ideas? Very disapointed since we do not use the welder much.

    Thanks

    Denny
    Last edited by Dennis Hiddemen; 02-14-2013, 11:20 AM.
Working...
X
Special Offers: See the latest Miller deals and promotions.