Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

need to set up dc inverter for tig welding

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • need to set up dc inverter for tig welding

    inverter has 300 amps 32 volts. need to know is high frequency kit with pedal, torch and flow meter available or is scratch start with pedal and flow meter the better choice? any recommendations on equipment

  • #2
    Him, My ESP hasn't kicked in. whats your FRACKEN (Battlestar Galactica terminology) model of machine?????

    Comment


    • #3
      tig

      you don't need a achf unless your welding alumimun. start with out all the extras,such as foot pedal that is for, later. fab. shopes use them for production welding,and most of the weling is done with pipe rotated as they weld. some welders i know, use the scrach ,and you can. i have been told on fine welding ,such as root passes in hpp pipe, some like it better. i use both and i know your machine. the scrach does have the ablity to kind of,narrow in the amps on the tungsten. so it's a personnel. up to you
      argon gas is very good,but helium can also be used. anyway.
      for steel use 2% tungsten and as well as on stainless,,,dcsp. if you are welding achf with aluminum use 100% prue tungsten.
      don't get bogged down on all the extras. you have a good machine and i know this machine. that remines me of buying a car. extra this and that. gee's i just want a car that works.

      Comment

      Working...
      X
      Special Offers: See the latest Miller deals and promotions.