Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Roughneck 2E

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Roughneck 2E

    I have a roughneck petrol welder and I have no output on the welding side as well as no voltage output, the rheostat is ok as well as the static Board and slip ring brushes look good! Do I need to use a battery to excite the rotor windings? Windings measure ok I did find one diode D1 short circuit on the static board and replaced it but still have no output as well as no voltage on the 240volt socket out lets the power switch I checked and change according to the test I am performing, just wondering if anyone can help me?
Working...
X
Special Offers: See the latest Miller deals and promotions.