Announcement

Collapse
No announcement yet.

Miller XMT 304 CC

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Miller XMT 304 CC

    I am new to welding. I acquired a Millermatic 175 and can do basic mig.

    I have a Miller XMT 304 cc. Not a cc/cv.

    I am hooking it to a 220 line with a 50 amp breaker. I assume this is adaquate for basic stick welding.

    That is my question. Will the 50 circuit be ok? I do not plan on using it at max.

    Any thoughts or ideas are welcome.

    Thanks

  • #2
    According to the owner's manual, it requires 47 amps. A 50 amp breaker ought to be just fine.

    http://www.millerwelds.com/om/o2208as_mil.pdf

    Comment


    • #3
      Setting on the Miller 304 cc

      Ok. Now what are the basic settings for the Miller XMT 304 CC. I am going to weld on a front bucket on a backhoe. Repair work. I split the corner and need to repair.

      I have not used the 304 and need to determine the proper settings.

      Comment


      • #4
        I have never used one, but there should be some starting settings listed in the manual.

        Comment


        • #5
          Make sure when you power it up ( Wiring the plug ) When hooking it up to single phase you do not use the red wire.

          Set the machine on panel verses remote ( Remote is for changing your amps with a remote that you dont need.

          And set it to arc weld and you should be fine.

          Comment


          • #6
            I would use this online weld calculator to find a good starting point for your weld settings.
            http://www.millerwelds.com/resources...calculator.php

            Comment

            Working...
            X