Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Syncrowave 200-no tig

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Syncrowave 200-no tig

    i currently have a syncrowave 200. Don't really know what happened just one day it wouldn't start the tig arc. It stick welds fine. Tried a new foot remote an still nothing... no arc or gas flow. Shops around are so dang expensive. Looking for a place to get a new board maybe? Any hints or thoughts appreciated!

  • #2
    Bump

    Comment


    • #3
      Can you post your machine settings while in tig mode please?

      Did you try both AC and DC polarity in tig mode?

      Comment


      • #4
        zachary

        Yes i tried all polarities. still nothing

        Comment


        • #5
          Serial#, and what does the machine do when you paper clip (jumper) "A" to "B" on the 14 pin machine amphenol,

          Comment

          Working...
          X
          Special Offers: See the latest Miller deals and promotions.