Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.


Announcement Module
No announcement yet.

Narrow Tip for M-100 Gun

Page Title Module
Move Remove Collapse
Conversation Detail Module
  • Filter
  • Time
  • Show
Clear All
new posts

  • Narrow Tip for M-100 Gun

    I am looking for a narrow tip and nozzle, 030 wire, like the Bernard TT Series that will fit or can be adapted to fit the Miller M-100 gun on the MM211. I have had a couple of jobs where the welds are in tight places and the standard M-100 nozzle is just too big. Miller only lists one nozzle for this gun.

    I just don’t do enough of this “tight place” welding to justify buying a Bernard gun. Ideas, suggestions?

  • #2
    Miller just makes one size nozzle for that gun. They do make a 3/8" for the M-25 gun but its too big to fit the adaptor. I am sure i could make a nozzle adaptor to mate the M-25 to a M-15/100 gun. Let me look...Bob


    • #3
      The Miller M-25 nozzle adaptor is a 3/8" coarse thread and the M100 is a 3/8" fine thread. Prob made for a reason beyond me. If they were the same they would interchange just fine...Bob


      • #4
        I can make you a M-25 sized adaptor that fits your M100 gun. Can you get the M-25 small nozzles or do you need me to get some? ...Bob


        • #5
          PM Sent


          Special Offers: See the latest Miller deals and promotions.