Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

TB302 start problem

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • TB302 start problem

    Hi All
    So my TB302 with a Kohler engine is doing its job but needs an oil change.
    Oil and filter changed
    Now it doesn't start. Turns over great.
    Go over and top off the gas tank, it only took 6 gals.

    I'm thinking either the "Low oil presure switch" or the Gas solenoid.
    Can't find either of these but I'm not sure what they look like.

    What are your thoughts
    Hay Cruzier you got your ears on?

    Thanks in advance.

  • #2
    Found It!

    We pull the unit off the truck so we could really see everything.

    Well the oil drain hose had a wire wrapped around it and we broke that wire when we pulled the hose to drain the crankcase.

    Spliced it and it started right up.

    OK a little embarrassed
    But hey we found it

    Comment

    Working...
    X
    Special Offers: See the latest Miller deals and promotions.