Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.


  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Newbie needs advice...

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Newbie needs advice...

    I'm a first time welder on a brand new Millermatic 140. I carefully dialed in all the adjustments and gas dials properly but I can't seem to get my wire feed in synch with how rapidly my weld is using up the wire, so each time I stop welding there is a 4-6" piece of wire projecting out of the handpiece that I feel needs to be cut off to get a manageable length of wire to start welding again. Any advice on what I need to do to correct this from happening would be super. I'm very happy with the welds I am getting and all, I just don't feel like something is working correctly and I don't have a clue as to how to start to correct it.

  • #2
    Sounds like you are pulling your gun away as you stop welding

    Comment


    • #3
      Newbie needs advice...

      Yeah that happens sometimes, or material could be very dirty.

      Comment

      Working...
      X
      Special Offers: See the latest Miller deals and promotions.