I just baught a dexter 3500# torsion axle from a friend. I want to use it for a smoker trailer, but the axle is too long. Can i cut and shorten the axle? I did read a few articles saying the rubber does not run the whole length of the axle, just from each end in a few feet. This axle is made for a 80" frame. The smoker tank is 30" wide and I want to keep the tank close as possible to center. So at 60" I would have 15" on each side from smoker tank to side of trailer. This way I can reach the doors. I dont even know is I can take 20" out of the axle.? any help is appreciated. Thanks, Joe
No announcement yet.
Cutting and welding Dexter torsion axle?