Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Miller 2050 Press Alert

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Miller 2050 Press Alert

    I have two Miller 2050 Plasma cutters and the newer one quit working and gives press alert. When turned on with reg set at 70psi both pwr and ready lite comes on. 2 1/2 seconds later the ready lite goes out and press lite comes on. I have correct press thru reg to solenoid valve. The press switch ohms out closed above 40psi. Since I have 2 machines I swapped the four PC boards.(2 on each side) I also swapped the torch/hose assembly. Any suggestions as what to try next?
Working...
X
Special Offers: See the latest Miller deals and promotions.