If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
If you have some empty spools for your MIG you can re-spool it on to one of them. Just get a peice of all thread and sandwich the spool between two nuts and washers. Then put the end in your drill and spin it to reel on the wire from the larger spool. Keep the allthread fairly short, just enough to go in the drill chuck and pass thru the take up spool with the nuts and washers on it. You may need to double nut it to keep it from loosening while reeling. Put the large spool on a rod so it can roll freely while you do it. Hold a little tension on the wire while it feeds on to the take up spool.
Will it physically fit in your machine & only the hole size if different?
Lincoln ac/dc 225
MM200 black face
Whitney 30 ton hydraulic punch
Lown 1/8x 36" power roller
Arco roto-phase model M
Vectrax 7x12 band saw
Miller spectrum 875
30a spoolgun w/wc-24