Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.


Announcement Module
No announcement yet.

xmt 304 as tig welder questions..

Page Title Module
Move Remove Collapse
Conversation Detail Module
  • Filter
  • Time
  • Show
Clear All
new posts

  • xmt 304 as tig welder questions..

    When i bought my xmt it came with a complete tig setup. Torch with gas valve, foot pedal and the cups you would ever need. My big concern is the lift arc tig, i have always used hi frequency start. Is there any tricks to use it? I will be using it to weld in my cage in my firebird. Worse case
    I will borrow my buddies dynasty 200.


  • #2
    Its pretty easy, just put the tungsten on the work surface (no worries on contamination as there is no amperage there. then slowly lift the torch up, and off you go. Can't get much more simple


    • #3
      Yup, I also agree, no need for a dynasty if you have a XMT.


      Special Offers: See the latest Miller deals and promotions.