Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.


Announcement Module
No announcement yet.

problem with miller welding equipment

Page Title Module
Move Remove Collapse
Conversation Detail Module
  • Filter
  • Time
  • Show
Clear All
new posts

  • problem with miller welding equipment

    I have a miller 200LE aead welder, the first problem started with low AC power output 50 volts. Next was real low weld output, after doing some troubleshooting I put new brushes and cleaned slip rings (3). Still had same trouble,next I found two blown diodes on regulator circuit card. After repairing that my AC output was OK 120 volts, now the weld output is still real low same as when this problem started.
Special Offers: See the latest Miller deals and promotions.