Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.


Announcement Module
No announcement yet.

spoolmate 200 with millermatic 175, possible?

Page Title Module
Move Remove Collapse
Conversation Detail Module
  • Filter
  • Time
  • Show
Clear All
new posts

  • spoolmate 200 with millermatic 175, possible?

    I own a millermatic 175 welder. I recently acquired a miller spoolmate 200 with the WC-24 controller (my dad used this set up with his XMT driver). My question is can I hook this spoolmate up to my 175 to weld aluminum?

    My initial research says no but I can buy a SGA-100 that will allow me to do so. Thoughts or suggestions

Special Offers: See the latest Miller deals and promotions.