If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I own a millermatic 175 welder. I recently acquired a miller spoolmate 200 with the WC-24 controller (my dad used this set up with his XMT driver). My question is can I hook this spoolmate up to my 175 to weld aluminum?
My initial research says no but I can buy a SGA-100 that will allow me to do so. Thoughts or suggestions