Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Dialarc HF remote contactor not working.

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Dialarc HF remote contactor not working.

    Went to do some tig welding on a pocket knife for a neighbor. Remote contactor worked one time and quit Checked the plug on the pedal and it is working . Any suggestions ? I am pretty sure its a 1977 model .
    Last edited by jmz; 12-19-2012, 06:18 PM. Reason: add info

  • #2
    No Serial#, no can help......

    Comment


    • #3
      Hh012516

      Comment


      • #4
        If the microswitch in the pedal is ok, you likely have a stuck CR3 relay in the machine. There are 3 relays, CR3 is the one furthest away from the square bridge. Give it a tap with a screw driver end, or replace it.

        Comment


        • #5
          Thanks. I will check it out.

          Comment


          • #6
            I tried tapping on the relay while stepping on the pedal and it still did not want to close on its own. I found a new relay on ebay and bought it. Looks like they are hard to come by. ????

            Comment


            • #7
              Thank You cruizer $25.00 fix

              Comment

              Working...
              X
              Special Offers: See the latest Miller deals and promotions.