Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.


  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

miller 225 g wont fast idle

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • miller 225 g wont fast idle

    hello, i have a 225 g with the onan performer engine. carb was full of dirt and crud. rebuilt with new parts. runs fine now but will not rev up for welding power. if i push throttle back it runs full speed but governer wants to pull back to idle. any ideas? thanks!

  • #2
    Again, can't do much without a serial#

    Comment


    • #3
      throttle solenoid

      The govenor is suppose to pull the throttle back. Does the electric solenoid fot the throttle work?

      Comment

      Working...
      X
      Special Offers: See the latest Miller deals and promotions.