If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Are you able to use any gas lense's on the Miller Diversion 180? without switching out the torch or torch head. And Is the machine able to weld titanium?
Absolutely on both counts. The Diversion uses an aircooled torch, WP17 style I believe. I use 17 series gas lenses on the torch that came with my Dynasty. Works a treat. The gas lenses I get are "stubby" gas lenses.
Welding titanium is very much like welding stainless steel. The Diversion can do both including Aluminum, magnesium, bronze, cast iron, even lead if you must. Zinc not so much. Brass is a bit tough, but can be done too.
Nothing welded, Nothing gained
3 ea. Miller Dynasty350DX
ThermalArc 400 GTSW
MillerMatic200 with spoolgun
Linde UCC305 (sold 2011)
PlasmaCam CNC cutter
Fadal Toolroom CNC Mill
SiberHegner CNC Mill
2 ea. Bridgeport
LeBlond 15" Lathe
Haberle 18" Cold Saw
Doringer 14" Cold Saw
6 foot x 12 foot Mojave granite