Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Spectrum Lynx Plasma without generator

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Spectrum Lynx Plasma without generator

    I'm looking for any information for wiring a Miller Spectrum Lynx plasma directly to power without the needed generator...any help is appreciated...thx in Advance.

  • #2
    You have a cabel on the back of the Lynx A, B, and D are the 220 volt AC power going in. A and B are hot and D in ground. Pins C and G are the 12 volt DC control. G is possative C is Neggative. If you would like me to e-mailyou a schematic send me an e-mail tlux@millerwelds.com

    Comment


    • #3
      Sorta kinda though you'll still need the 12Vdc, to make it go.

      Comment


      • #4
        Miller has the best staff ever when it comes to their plasma cutters.
        Thanks Miller for all your help with my Spectrum 375.
        Working great and with the stickers it will look like new very soon.

        Ji

        Comment

        Working...
        X
        Special Offers: See the latest Miller deals and promotions.