Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.


Announcement Module
No announcement yet.

How can I learn to Fit?

Page Title Module
Move Remove Collapse
Conversation Detail Module
  • Filter
  • Time
  • Show
Clear All
new posts

  • How can I learn to Fit?

    I'm currently in welding school,and it only teaches welding.I would like to come out of school in may knowing how to Not only weld but fit to.

  • #2
    Find an old guy like me and watch Learn how to read blueprints and drawings to get an understanding of what the part is. Don't look at the drawing as a whole break down parts of it in your head so you don't get confused with all of the lines. It will come to you pretty quick. Where are you located? ...Bob


    • #3
      There is also a book or two on the subject, though I forget the names. You can also buy the pipe templates and practice at home in your off time laying out and cutting branch tees, etc. The more you do the better sense it will make.


      Special Offers: See the latest Miller deals and promotions.