Announcement

Collapse
No announcement yet.

Syncrowave 351 power question

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Syncrowave 351 power question

    I just picked up a Syncrowave 351. My welding plug in my garage is breaker'd 50 amps. Is this going to be too small to run this welder? I found info on the web today saying that it needed to be breaker'd at 100.

    I am fairly new to tig welding and have always used my mig 140 or my DVI millermatic. The syncrowave was given to me by my uncle today and if I can figure it out, I will buy it off him. So I have been on this site all day trying to figure out how to work this beast.

    Thanks for you help on my first question.

  • #2
    Ideally this machine should have 100A service. You can look up the owners manual here, tells the demands, wire and breaker sizes.

    Comment


    • #3
      Syncrowave 351 power question

      Thank you very much.. I downloaded the manual but I couldn't find that spec.. I appreciate your response

      Comment


      • #4
        With that syncro 350 you are going to need every bit of that 100 amp fuse. 60 would only work for a short time. Everytime a breaker trip the life expectancy gets shorter every time it trips. Use 100 and save a head breaking problem. Good luck

        Comment

        Working...
        X