Announcement

Collapse
No announcement yet.

settings

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • settings

    Hi, I need some help. I have a Millermatic 130xp and I want to practice some welds on some 1/4" steel plating. I need to know the regulator, wire speed, and amp settings I should start off with. I can adjust the other settings accordingly as I go but I need to also know if the gas regulator setting always remains the same no matter what you are welding. Thanks

  • #2
    Here's the manual for the 130XP.
    http://www.millerwelds.com/om/o1316f_mil.pdf
    Lincoln Vantage 400
    Trailblazer® 302 Air Pak™

    Miller Dynasty® 350
    Millermatic 350P Aluminum
    Millermatic® 252
    Syncrowave 351
    Lincoln LN-25 Pro

    Multimatic™ 200

    XR-Aluma Pro Gun
    Diversion™ 180

    Spectrum® 625 X-TREME™

    Thermal Dynamics® Cutmaster® 52
    Victor Oxy/Acetylene Set

    Comment


    • #3
      I think you should drop down to 1/8" or under to practice on. 1/4" will be pretty tough for that little welder...Bob
      Bob Wright

      Spool Gun conversion. How To Do It. Below.
      http://www.millerwelds.com/resources...php?albumid=48

      Comment

      Working...
      X