Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.


  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

settings

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • settings

    Hi, I need some help. I have a Millermatic 130xp and I want to practice some welds on some 1/4" steel plating. I need to know the regulator, wire speed, and amp settings I should start off with. I can adjust the other settings accordingly as I go but I need to also know if the gas regulator setting always remains the same no matter what you are welding. Thanks

  • #2
    Here's the manual for the 130XP.
    http://www.millerwelds.com/om/o1316f_mil.pdf

    Comment


    • #3
      I think you should drop down to 1/8" or under to practice on. 1/4" will be pretty tough for that little welder...Bob

      Comment

      Working...
      X
      Special Offers: See the latest Miller deals and promotions.