Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.


Announcement Module
No announcement yet.

PipeWorx and PipePro Stick Weld "Hot" Start

Page Title Module
Move Remove Collapse
Conversation Detail Module
  • Filter
  • Time
  • Show
Clear All
new posts

  • PipeWorx and PipePro Stick Weld "Hot" Start

    I do know that our Pipeworx and PipePro machines have a "Cold" Start funtion for stick welding. However, we are getting "Pinholes" as a result of the "Cold" Start that keep showing up in x-ray on code units we build.

    Is there a "Hot" start adjustment or function on these machines that we can utilize to eliminate these pinholes at startup?

    Any help at all would be appreciated. These repairs and re-xray are getting out of hand.
Special Offers: See the latest Miller deals and promotions.