Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.


  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

MillerMatic 200 + SpoolMate 100

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • MillerMatic 200 + SpoolMate 100

    Have use this gun frequently, with a 211...but never with steel wire (NOT flux-core), always with aluminum.

    Will this gun run steel wire with the 200?

    And can I use ARGON...instead of CO2, since I have Argon in abundance?

  • #2
    Steel works fine with any spoolgun, though if your a welder, you should know better on the Argon issue

    Comment


    • #3
      Originally posted by buzz254 View Post
      Have use this gun frequently, with a 211...but never with steel wire (NOT flux-core), always with aluminum.

      Will this gun run steel wire with the 200?

      And can I use ARGON...instead of CO2, since I have Argon in abundance?
      I assume you mean Argon Mix ( 75-25 ) Not straight Argon !
      Pure Argon is for welding aluminum !

      ...........Norm

      Comment


      • #4
        I think the bigger question is how are you going to run the Spoolmate 100 on a MM200. Just my thoughts...Bob

        Comment


        • #5
          About the only way would be coupled to an SGA 100 with a modified control cable plug to fit the MM200 4 or 14-pin spoolgun control receptacle depending on its generation.

          Comment


          • #6
            will the spoolmate 100 direct conect to my millermatic 200 serial number JF946510

            Originally posted by aametalmaster View Post
            I think the bigger question is how are you going to run the Spoolmate 100 on a MM200. Just my thoughts...Bob
            my millermatic has a four pin spot for a spoolgun

            Comment


            • #7
              Originally posted by mitchcv View Post
              my millermatic has a four pin spot for a spoolgun
              Correct but not all Spoolguns work on all machines, you have to have the correct spoolgun

              Comment

              Working...
              X
              Special Offers: See the latest Miller deals and promotions.