Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

welder question

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • welder question

    I just purchased an older canox 250 amp welder, looking at the machine I would say it is identical to a miller and also a memco?

  • #2
    Originally posted by rustymfg@hotmail.com View Post
    I just purchased an older canox 250 amp welder, looking at the machine I would say it is identical to a miller and also a memco?
    A Canox 250 is a MM250. Memco was sorta off an on with Miller, they did push out thier own lineup of not so good stuff though.

    Comment


    • #3
      welder question

      I bought it to run a wire feeder as well as plan on using it for a spool gun it should do all that just fine for me??

      Comment


      • #4
        Sure providing it has a 14 pin or 10 pin adaptor for the spoolgun, otherwise I don't think the spoolgun kit is available for it anymore.

        Comment


        • #5
          welder question

          Yea it has a 14 pin plug and also I bought it with a 25' spool gun

          Comment

          Working...
          X
          Special Offers: See the latest Miller deals and promotions.