If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
No announcement yet.
Stainless square edge butt weld Sched. 10, no gap, one pass , fusion.
I do a lot of sanitary welding and I do butt and run (fuse). It is very easy and it holds 250 psi without problems in 4 years. But if the joint is not 100% square, use filler wire. I run .035 tig wire. Not mig wire.