Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Stainless square edge butt weld Sched. 10, no gap, one pass , fusion.

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Stainless square edge butt weld Sched. 10, no gap, one pass , fusion.

    What do you think? Can you? How would you recomend doing it?

  • #2
    Originally posted by garm1248 View Post
    What do you think? Can you? How would you recomend doing it?
    What size pipe? Why do you want to do this?

    Comment


    • #3
      Yes you can fuse it, but why not just add some tig rod its easy.

      Comment


      • #4
        I do a lot of sanitary welding and I do butt and run (fuse). It is very easy and it holds 250 psi without problems in 4 years. But if the joint is not 100% square, use filler wire. I run .035 tig wire. Not mig wire.

        Comment

        Working...
        X
        Special Offers: See the latest Miller deals and promotions.