Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

new gun on my mm 250x

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • new gun on my mm 250x

    Well i finally took the plunge and spent the $275 on a M-25.I had been wishin for long time the gun was longer but was being tight with money.After 14yrs of a 10' gun i must say i,m lovin this 15 footer.Makes things alot easier to weld in the shop.Anyone else hating there 10 foot gun its worth the investment.
    Last edited by admweld; 10-30-2012, 02:35 AM.

  • #2
    Yeah, a longer gun is ok, but pretty tough on your drive system. A twist or 2 on your cable will make the drive slip. Often its best to also go with a single knurled drive roll to compensate and then loosen off the drive so that it's not working as hard.

    Comment


    • #3
      new gun on my mm 250x

      Bernard makes a nice 15 foot gun for Miller. I bought a couple on eBay for under $150 ea.

      Comment

      Working...
      X
      Special Offers: See the latest Miller deals and promotions.