If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I picked up a 3 turn weld remote for my Trailblazer 301G on Friday and finally had a chance to hook it up and try it just a few moments ago. I hooked the cable into the machine remote receptacle and flipped the switch from panel to remote, went inside and hooked the cable to the remote box. Threw a 1/8 7018 into the stinger and tried welding. There was hardly an arc no matter how hot I put the remote setting. I plugged a grinder into it and nothing. Walked over to the machine and it worked so I know it's not the plug.. Anything I am missing?