If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Got unit back from repair shop. Removed all covers, cannot see any physical damage to T1 or any of the wires or componants. When I took unit to shop the switch on the feed handle, when pressed would make the contacts just past the 120 volt source to make contact but quickley release and would do that a couple of times before stopping. The switch when checked at the entry to the front of unit makes connection when pressed. Cannot read any voltage on T1 in or out.
Machine started working after I removed the blade connector from the overload componant. Looking at the side of machine, the wire at top of the overload componant was removed to check voltage and when I reconnected the lead and pressed the trigger on gun the drive motor started working.