Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Troubleshooting a miller AEAD 200LE

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Troubleshooting a miller AEAD 200LE

    I just purchased today a miller AEAD 200le welder. Serial # HE802574. The engine runs fine and the 120v plugs work but it won't hold an arc while welding. I don't know much about the internal workings of the machine so I tried to pull up the manual on here but it brings up a machine with a dial control for amperage and this is one of the old machines where you still have to switch around the cables. Anyone have any ideas what it might be or where to get the proper manual for my machine? Thanks

  • #2
    You need to enter your SN whem looking up the manual otherwise you get the most current revision.
    http://www.millerwelds.com/om/o411b_mil.pdf

    Comment

    Working...
    X
    Special Offers: See the latest Miller deals and promotions.