Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

new welder needs help with welding test

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • new welder needs help with welding test

    I recently finished a trade school course in welding and the job i'm trying to get deals in Flux Core. I am by no means a master welder and i need all the help i can get!!

    Long story short, we didn't have but a few days training in Flux and it was only the side to side weld and a little flat. This company uses all positions in flux.

    The weld test is a simple one pass t joint vert and overhead on thin steel with the machine set on zero. Could ANYONE please recommend what to set the machine on volt and wire so i can hopefully go to work?

    Thanks in advance!!

  • #2
    new welder needs help with welding test

    The wire manufacture will give operating Parameters for each Specific Wire and size.
    With no real information it's hard to give speed and volt information.

    Comment

    Working...
    X
    Special Offers: See the latest Miller deals and promotions.