Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.


Announcement Module
No announcement yet.

Erratic arc

Page Title Module
Move Remove Collapse
Conversation Detail Module
  • Filter
  • Time
  • Show
Clear All
new posts

  • Erratic arc

    I'm having some erratic arc problems with my dynasty 200dx. Everything seems to check out fine like gas flow,connections,points(set at 0.010),good gas and tungsten. When I press on the pedal I get this buzz/tick so I take off the cover to see its the arc jumping the points. This is weird cause last time I fired it up it worked just fine. Also talked to a tech and he told me my boards are bad. I just bought the machine with only 25hrs on it and its a 07 model. The inside of the machine look fairly clean.
Special Offers: See the latest Miller deals and promotions.