Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.


Announcement Module
No announcement yet.

350P line voltage too high?

Page Title Module
Move Remove Collapse
Conversation Detail Module
  • Filter
  • Time
  • Show
Clear All
new posts

  • 350P line voltage too high?

    Got a new 350P and hooked it up and reading help 7. Checked my line input voltage and it reads 248-250 volts. Is this too high for machine and make it not run without help 7 coming on?

  • #2
    nevermind board was on 480 had to move to 240


    Special Offers: See the latest Miller deals and promotions.