Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Will an xmt 304 that only shows 460/575 3 phase on the back, work on 1 phase?

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Will an xmt 304 that only shows 460/575 3 phase on the back, work on 1 phase?

    Someone was offering a machine to me. The serial number is lb-174522. The manual from miller states it does do 3 and 1 phase but the back of the machine says different. Was it made 3 phase to keep it from leaving a job site or something? I don't want it if is either stolen or 3 phase only.

  • #2
    OK, If you have 460 or 575, its 3 phase. I have a difficult time wondering why you want to run it on single phase 460 or 575.... If your somehow thinking its going to run on 230 forget it!

    Comment


    • #3
      I don't have 3 phase at my house and I can't use a "3 phase only" machine. It's pretty cheap but I don't want it if I can't use it . I'd imagine that miller would have put "3 and 1 phase" on the back if it could do that. But this only has what I stated above "460/575 3 phase". If you say that it is a 3 phase only machine and won't run or run properly on 1 phase, that's good enough for me. I'll just pass on it.

      Comment

      Working...
      X
      Special Offers: See the latest Miller deals and promotions.