Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.


Announcement Module
No announcement yet.

Millermatic 130xp

Page Title Module
Move Remove Collapse
Conversation Detail Module
  • Filter
  • Time
  • Show
Clear All
new posts

  • Millermatic 130xp

    I have a Millermatic 130xp. It is about 11 years old under heavy use. Bead is looking high with .023 wire machine is turned all the way up. Is there a possible fix or is the welder just on it's last leg?

  • #2
    i used to own one myself, for the most part- bullet proof. start with the output contactor, check out the contact points, if they are ate up looking and not clean, replace it. i have replaced a few in the past. its kind of a pain but totally worth it if youre wanting to squeeze another 11 years out of it. great garage machine if you ask me


    Special Offers: See the latest Miller deals and promotions.