Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.


Announcement Module
No announcement yet.

Air Pak Owners

Page Title Module
Move Remove Collapse
Conversation Detail Module
  • Filter
  • Time
  • Show
Clear All
new posts

  • Air Pak Owners

    I finaly got 50 hrs on the air compressor part of my Air Pak.
    Time for the first oil change, the next is 500hrs later. I did not reset my hour meter so that at 500 hrs I will change the oil again. The oil will only have 450 hrs, but from now on the time will be exact.
    First, the book says 1.75 qts Mobil 1 synthetic ATF. Napa did not stock that oil.
    O' Reillys did not stock that oil.
    I finaly got it from the distributer.
    I open the hood of the welder, drop the oil, change the filters, and add the 1.75Qts of ATF, and it shows low on the stick.
    Then I see a decal under the hood that says 2.6Qts, that fills it up.
    So to recap buy 3 qts instead of 2 and start looking for the oil early (45hrs or so).
    Good Luck,
Special Offers: See the latest Miller deals and promotions.