If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I don't think you want to see it, or should I say, I don't want anyone to see it? I made a fire extinguisher holder for my welding cart today out of 16g. I cut a 5" circle with the plasma cutter and a 1" strip for the lip. I wanted to Tig the joint where the bottom & the lip meet. I started out ok but I made a mess of it pretty quick. I still can't get the hang of tig welding. I don't know if I'm not cleaning the metal good enough or what. I seem to have a hard time seeing the puddle. Anyway, I had to finish it up with my mig torch and then grind everything down. The finished product turned out ok, but it was not material for a how-to video. Very frustrating!
I'm going to break the cart down in the next couple of days so I can wire wheel everything and paint it. I'll send you some pics when I do.