Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.


Announcement Module
No announcement yet.

Need Help!!!

Page Title Module
Move Remove Collapse
Conversation Detail Module
  • Filter
  • Time
  • Show
Clear All
new posts

  • Need Help!!!

    Tomorrow I am going to take a welding test for a new job. I am going to be using the spray transfer method to weld 625 inconel with .045 diameter electrode on I think 1/8" thick plate. I have never welded this stuff or even heard of it till today. I need to know the amperage ranges, wire speed ranges, work angles, push or pull method?, and any manipulation patterns if there are any for vertical and horizontal welds. PLEASE HELP!!!

  • #2
    Need Help!!!

    Inconel hates to get too hot , if so it will turn black , I have heard it is just a higher grade of stainless


    Special Offers: See the latest Miller deals and promotions.