Announcement

Collapse
No announcement yet.

need 208 setup for miller syncrowave 300

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • need 208 setup for miller syncrowave 300

    I just bought a used miller syncrowave 300. The decal to setup the voltage for 208 on the welder itself is missing. The dumb manual says check the decal on the machine. it is a 208/230/460 adjustable voltage machine. Sorry, don't see ss#

    Settings:
    460 says have one connector plate on pins 3 and 4
    230 uses two plates. One on pins 2 and 3 and another on pins 3 and 4
    But the decal is torn off right when it gets to the setting for 208.

    How many plates and where?

    help is appreciated.
    Thanx, Mark

  • #2
    Link two studs far left and two far right leaving two studs empty in the middle.

    Comment


    • #3
      Originally posted by big mike View Post
      Link two studs far left and two far right leaving two studs empty in the middle.
      He is correct. The wiring diagram on page 27 of the generic manual shows it at the bottom of the diagram.

      The generic diagram is here: http://www.millerwelds.com/om/o350p_mil.pdf

      Comment

      Working...
      X