Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.


Announcement Module
No announcement yet.

millermatic 250x problems

Page Title Module
Move Remove Collapse
Conversation Detail Module
  • Filter
  • Time
  • Show
Clear All
new posts

  • millermatic 250x problems

    I have a millermatic 250x mig welder I purchased several years back, new. Having problems with the output voltage suddenly raising very high while welding.. normally have it set around 19-20v but spikes really high causing a huge arc.. I voltmeter tested the output of +26v with load (arc) and higher without a load. Any idea what might be the problem? One minute it will work fine and the next it acts stupid.. any help will be appreciated..

Special Offers: See the latest Miller deals and promotions.