Announcement

Collapse
No announcement yet.

Help-1 code on a syncrowave 250 DX tigrunner.

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Help-1 code on a syncrowave 250 DX tigrunner.

    Help 1 possible code?
    Last edited by firehousefabrication; 07-01-2013, 05:22 PM.

  • #2
    If you download the manual from this website and look on page 41 you will see:
    Help1 Display
    An SCR overcurrent or undercurrent condition has occurred.
    Turn power off and back on to correct condition.

    Comment


    • #3
      Unlikely to the above, as the help 1 persists, so your stuck with the problem being the Hall (lem) or problems with the main control board. The are Leds on the board, could tell you more with a serial#

      Comment


      • #4
        firehousefabrication

        miller said board problems
        Last edited by firehousefabrication; 07-01-2013, 05:22 PM. Reason: wrong info put down

        Comment


        • #5
          nope, your looking at help"0", my original t-shooting idea still stands

          It was born on 1/17/2007

          Comment


          • #6
            firehousefabrication

            you are correct. the HEPL-1 does say An SCR overcurrent or undercurrent condition has occurred. Turn power off and back on to correct condition. so with that any suggestions would be taken and greatly appreciated.

            Comment

            Working...
            X