If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
No announcement yet.
Another Syncrowave 180 SD Problem Thread! No Amperage Control!
On page 2 I said thanks for giving me a solution to fix the problem which it should have ended there but it did not. It continued. And then I said we can close the thread since the problem was fixed and it continued.
After reading many threads from this site and others I found threads similar to my problem and they ended up being board replacements. Also I found many other problems other than the board. This made me believe that there were many problems with the syncrowave and I posted Another syncrowave problem thread because I would figure you guys would be tired of seeing a new thread about them. Anyways I was at fault for not tearing the torch apart before putting a new tungsten (like everyone else does) and missing a piece of pure tungsten in the tail. But like I said I tried to end it on page 2 but it did not and now we are on page 4 talking about everything other than the original problem.
Wow! I went to this thread to decide if I should keep my 180SD or trade up and it sounded like the cheerleader's locker room after a bad game! Now I can't say I've been in the cheerleaders locker room, but I'm guessing......