If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
The "Net Wait" error is caused by a lack of communication between the PCM process control board in the Axcess power source and the other boards in the wire feeder, the WFM (Wire Feed Module) and the UIM (User Ineterface Module). This failure could be the PCM, the device net cord you discussed, or in the feeder.
If you have a spare system, swap feeder and/or cords to see if you can get a certain combination to work. If this is your only system you would have to take off the covers of both the power source and the feeder and observe the communication LEDs. These LEDs are larger and can illuminate in either a red color or green color. When everything is working correctly they will all be green. But when there is a failure, as in a "Net Wait", the color of these LEDs and if they are solid lit or flashing will help determine where the failure is.